If enabled, you can choose whether the siren sound produces a single tone or a sustained tone. If you switch the system on, this detector will always be on. If enabled, this detector cannot be bypassed. You can activate this yourself as you wish. A 24 hour zone means that an alarm will always be triggered when detection is detected, even if the whole system is switched off. The delay zone allows you to set the entry delay time, the exit delay time, and the power-on delay time. Direct speaks for itself, when detected an alarm will follow immediately. You can also select multiple areas so you have more flexibility in when a detector should do its work.ĭirect zone, or delay zone or 24-hour zone or disabled. Here you set which zone or areas this detector should work in. In the settings you see the following options:Ģ, because we registered this detector as second. It is therefore more logical to use names such as Living room or Kitchen / Bedroom. Of course, the names of the detectors can be changed to any name in the detector settings. The PIRCAM was our first device and in our example is called Wireless zone 1. We have connected the PIR as the second device to the Hub and therefore it has automatically been given the name Wireless Zone 2. We will therefore use this as an example to show which settings can be chosen. One of the most commonly used devices is the PIR for indoor use. This will check the software and update it if necessary. Select Dutch, and the system will reboot to welcome you in Dutch.Īlways check if the Hub is equipped with the most recent software, by clicking on maintenance and device version. One of the settings is changing the language. Go through the settings menu one by one to get familiar with the system. Once you click on the AX Pro Hub in the Hik-Connect app, you’ll see a hexagonal symbol in the top right corner that takes you to the settings. However, this needs to be selected in the Hub settings. The Hub speaks dozens of languages, including Dutch. It can, for example, confirm commands or alert in the event of an alarm. The Hub has a built-in speaker that can provide support during installation or use. It’s almost time to connect the detectors, sirens and remote controls. Now most of the work is actually done, as the rest of the detectors are completely wireless and battery operated. A voice from the Hub will confirm the status of the access point.Īttach the cover of the Hub to the wall at the location where you would like the Hub to be fixed, and then slide the Hub onto the cover. If this is not the first time you are connecting the Hub, or if there is another reason why you cannot see the WiFi network of the Hub when searching for WiFi networks, you can also manually reactivate the access point by briefly pressing the reset button on the inside of the Hub. During a first installation, the access point of the Hub is switched on by default. The software will then program your WiFi network into the Hub, so that you can connect to your own network wirelessly via WiFi. You should first enter your own WiFi password when prompted in the Hik-Connect app, and then connect to the Hub’s temporary WiFi password. The name of this temporary WiFi network starts with HAP and then a number of letters and/or numbers. The Hikvision Hub temporarily broadcasts its own WiFi network during initial installation.
0 Comments
Leave a Reply. |